fedora-logo lasercutted on a stainless steel plate
Freitag, 31. Juli 2009שָׁלוֹם
Fedora has one of the easiest logos, because it is a design with very simple figures of geometry.
You need 5 min or less. Don’t believe?
1.)
create 3 circles radius= 25mm 30mm 35mm
2.)
Create some helplines. Use for lenght the radius of the inner and outer circle
3.)
Create 2 new helplines with 30° and 45° based from vertical helpline
The point of intersection is the middle of new circles with radius 5mm
4.)
Create a new vertical line down to the middle circle and another 7,83 mm to the left. [1]
5.)
Remove all helplines
6.)
Clip all lines, which are unnecessary
7.)
Copy the whole and make a 180° turn for the second
8.)
Merge both, center the overlaps with helplines,
make a new circle with radius 90mm
and create the corner at bottom left
9.)
Remove the helpline and clip and the corner to the circle.
10.)
Round the corners in the f with radius 5mm
and the corner of the “voice” with 15mm
Some dimensions:
___ T H E ___ R E S U L T ___
So long and thanks for all the fish :-)
שִׁמְעוֹן
[1] Why 7,83?
It is the cord of the 2 centerpoints of the circle in an angle of 15°
chord=2 x radius x sinus (alpha/2)
chord=2x30xsin(15/2)=7,83
